Varme 7m² Trade Carbon, Foam Underlay, PE Sheet, Programmer, Heat Pak
Our carbon heating film is ideally suited for installation beneath Vinyl or Carpet floors. At less than half a millimeter thick , it has a negligible effect on floor height. The film is laid over our exceptional 6mm Depron floor insulation (which replaces the standard flooring underlay) to give a minimal effect on your floor height - less than 6.5mm! This makes it ideal for use in both new buildings & renovations or refurbishments where floor height can be vitally important!
Heat Output - The film is designed as a heating system (not just floor warming) & gives an even heat coverage beneath the whole floor. It is available in two power outputs 130w per sqm for ordinary home heating & 160w per sqm for conservatories where higher heat losses are experienced.
Simple to install - The installation is so simple it can be done by anyone with even the most basic DIY skills, leaving your electrician to connect it up to the mains for you. Please follow the link for further
Quality - The heating film is manufactured in the UK in a BEAB approved factory & has been used worldwide for many years. It is extremely reliable & comes with a standard 10 year manufacturers warranty, but should last a lifetime!
Digital control - The control of the heating system is via our simple to operate, digital thermostat which has a 7-day/24 hr timer built in. The thermostat is unobtrusive & takes up the same space as a standard light switch
TPVD Codes come with a Double layer of 6mm Depron insulation/underlay (TPVS Codes for single layer)
TPVD - Carbon Film system for Carpet/Vinyl Flooring Includes
- Carbon Film Heating Elements
- Double Layer of 6mm Depron Insulation (12mm total)
- Heat-Pak Dual Overboard
- Dielectric Membrane
- Digital Thermostat Programmer